Linx-technologies MDEV-xxx-NT Bedienungsanleitung Seite 1

NT Series Master Development System User's Guide

– – – –BOARD CONTROLMODE_SELTX_SELRNG_SELRX_SELCH_BD_CTLALL_ENTR_CTL1TR_CTL2DATA_CTL1DATA_CTL2PROTO_LEDPDNTX_LEDRX_LEDSTDBYACTV_LEDPDN_LEDSTBY

– – – –Range Test Area12J2VCCMVCCIN1VCC2GND3NC4COM5NO6U4MAX4544EUTT/R_SEL_RDATA_MTGNDVCCDATA_IN_RDATA_OUT_RGNDLEDGREENR18620D0LED-0805-GRNVCCG

– – – –Single RoutingEVALUATION AREA SIGNAL ROUTINGLEDS11C24324C586SW4GNDGNDCS1_SCS2_SCS0_S11C24324C586SW5GNDGNDBAUD1_SBAUD0_SORANGED4R25200 o

DisclaimerLinx Technologies is continually striving to improve the quality and function of its products. For this reason, we reserve the right to mak

Table of Contents 1 Introduction 2 Ordering Information 2 NT Series Transceiver Development Board 2 Board Objects 3 Initial Setup 3 Troubleshoot

– –IntroductionThe Linx NT Series RF transceiver modules offer a simple, efficient and cost-effective method of adding wireless communication capab

– – – –Board ObjectsNT Series Transceiver Development Board1234567891011121314151716Ordering InformationOrdering InformationPart Number Descri

– – – –• Make sure that the Baud Rate and Channel switches are set the same on both boards• Check that the antennas are connected• Make sur

– – – –6The Power AreaThe Power Area has two switches that control power to the board and the type of operation (Figure 7). The Master Power s

– – – –To achieve maximum range, keep objects such as your hand away from the antennas and ensure that the antennas on the boards have an unob

– – – –The three position slide switch (2) controls the CMD_DATA_TYPE line. This line tells the module that the data coming in on the CDI is e

– – – –12The “Read Active Settings” button at the bottom (Figure 16) reads the existing configuration settings from the module and adjusts the